Pretraživanje
Prikaz rezultata 1-10 od 22
Sensing gas type and pressure with multipurpose device based on seebeck effect
(Institute of Electrical and Electronics Engineers Inc., 2019)
The aim of this work was to experimentally explore possibility of gas type and pressure detection using ICTM multipurpose device based on Seebeck effect. For this purpose, experimental procedure was established which allowed ...
Temperature Measurements with Four-Resistor Sensor Patterned on Golden Layer
(Institute of Electrical and Electronics Engineers Inc., 2018)
Test of a sensor with four resistors structure on its sensitivity as a temperature probe is described. The chip is sensitive on a temperature difference between Si substrate and air and less sensitive on the temperature ...
A measurement setup enabling automatic characterization of silicon piezoresistive MEMS pressure sensors
(Institute of Electrical and Electronics Engineers Inc., 2017)
In this paper a measurement setup is presented that enables automatic characterization of silicon piezoresistive MEMS pressure sensors. It is used for determination of the pressure and temperature dependences of sensor ...
Simultaneous Reactive-Power and Frequency Estimations Using Simple Recursive WLS Algorithm and Adaptive Filtering
(IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC, PISCATAWAY, 2011)
A new simple approach to the design of digital algorithm for simultaneous reactive-power and frequency estimations of local system is presented. The algorithm is derived using the weighted-least-square method. During the ...
Power Components Estimation According to IEEE Standard 1459-2010 Under Wide-Range Frequency Deviations
(IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC, PISCATAWAY, 2012)
This paper proposes an accurate and computationally efficient time-domain implementation of the IEEE Standard 1459-2010 for power measurements. The most important parts are adaptive low- and bandpass finite-impulse-response ...
ICTM pressure transmitter in the feed water system of the thermal power plant
(Institute of Electrical and Electronics Engineers Inc., 2016)
This paper presents implementation of pressure transmitters, developed at Institute of Chemistry, Technology and Metallurgy (ICTM), within the feed water system existing in thermal power plant TENT-A located in Obrenovac, ...
Analytical modelling of the transient response of thermopile-based MEMS sensors
(University of Banja Luka, Faculty of Electrical Engineering, 2015)
This work presents an analytical model dedicated to study of the transient response of multipurpose MEMS devices based on thermopile sensors. In general, thermopile sensors response depends on ambient temperature, thermal ...
Prototype of the multichannel acquisition system developed for ICTM pressure transmitters
(University of Banja Luka, Faculty of Electrical Engineering, 2015)
This paper presents a prototype of the multichannel acquisition unit AKV-100 developed for purposes of pressure and temperature measurements using proprietary ICTM pressure transmitters TPa-110 based on MEMS piezoresistive ...
Self-Powered Wearable Breath-Monitoring Sensor Enabled by Electromagnetic Harvesting Based on Nano-Structured Electrochemically Active Aluminum
(MDPI, BASEL, 2023)
Self-powered sensors are gaining a lot of attention in recent years due to their possible application in the Internet of Things, medical implants and wireless and wearable devices. Human breath detection has applications ...
Frequency-response-controlled multiple-resonator-based harmonic analysis
(INST ENGINEERING TECHNOLOGY-IET, HERTFORD, 2018)
This Letter proposes a modified method for the dynamic harmonic analysis of signals with non-stationary harmonics, which is based on the previously proposed multiple-resonator observer structure. An optimisation technique ...